#WIRESHARK IP ADDRESS FILTER LOCAL MAC#

For example, to keep from capturing http and ssh traffic to/from any host and any packets to or from 192.168.5.22, not host 192.168.5.22 and not port 80 and not port 22

The downside is those packets are not captured if you later want to inspect them and you can't change the filter selected this way during a capture session. The display filter syntax to filter out addresses between 192.168.1.1 192.168.1.255 would be ip.addr192.168.1.0/24 and if you are comfortable with IP subnetting, you can alter the /24 to change the range. It makes the capture take less memory and disk by avoiding capturing packets you're telling it to ignore. However, if the addresses are contiguous or in the same subnet, you might be able to get away with a subnet filter. In this case, you can see my phone received an IP address of 192.168.1.182 from the router, and you can identify the device as an Apple phone by looking at the vendor OUI.

#WIRESHARK IP ADDRESS FILTER LOCAL MAC#

Look at the Address resolution protocol section of the frame, especially the Sender IP address and Sender MAC address. While not strictly your question, I prefer to do filtering in the capture filter (double click the interface name in the capture-options dialog), whose syntax is exactly like tcpdump. Use Wireshark’s Packet details view to analyze the frame. Tcp.dstport != 80 suffers from a similar problem having tcp.dstport != 80 turns out to mean 'match ONLY tcp traffic, but only tcp that is not dstport = 80' You can also limit the filter to only part of the ip address. Here's a complete example to filter http as well: not ip.addr = 192.168.5.22 and not tcp.dstport = 80 ip.host have the same effect with ip.addr. For example, when connecting to 192.168.5.254 from 192.168.5.22, ip.addr != 192.168.5.22 doesn't match *.22 IP, it matches *.254 and thus the packet matches the filter expression. For example, to display only those packets that contain source IP as 192.168.0.103, just write ip.src192.168.0.103 in the filter box. It might seem more logical to write it as ip.addr != 192.168.5.22, but while that's a valid expression, it will match the other end of the connection as not being the specific ip and still be true. Here's a complete example to filter http as well: not ip.addr 192.168.5.22 and not tcp.dstport 80 tcp.dstport 80 suffers from a similar problem having tcp. You could also write it like so: not (ip.addr = 192.168.5.22) With the negative match like you have, you need both conditions to be true to filter off your IP, thus and instead of or.

Wireshark ip address filter local