autodesk quantity takeoff measure rectangle

Under such circumstances, no deduction is required for A type walls, but when B type walls are selected, for every junction deduction of half breadth of A type walls (main walls) should be constructed from the total center length of B type walls.Īt corners of the building where two walls are intersected, no subtraction or addition is necessary.įor live demonstration of centre line method, go through the following video tutorial. Then all A type walls should be considered together individually. In the same manner, obtain the total centre length of walls of second type and manage this individually.Īssume, the exterior walls (main walls) belong to A type and inside cross walls belong to B type. Obtain the total centre length of all walls of one type and continue as similar way as above. If there are various types of walls in the buildings, every set of walls should be managed individually. This method is effective for rectangular, circular polygonal (hexagonal, octagonal) buildings without inter or cross walls.įor buildings with cross or partition walls as well as each junction, half breadth of the corresponding item or footing should be deducted from the total center length.įor a building containing one partition wall or cross wall with two junctures, deduct one breadth of the corresponding item of work from the total centre length. selection sets, quantity takeoff, cost and schedule data, clashes and many more. This method is very fast but needs special attention & considerations at the junctions, intersection point of partition or cross walls. To import the project into BEXEL Manager, BX3 file format from Autodesk. Under this method, the length will be unchanged for excavation in foundations, for concrete in foundations, for all footings, and for superstructure (with slight variation for cross walls or number of junctions). Obtain the total length of centre lines of walls of similar type with similar type of foundations & footings and then get the quantities by multiplying the total centre length with the corresponding breadth and height. Under this method, total length of centre lines of walls (long & short) should be determined.

In the Takeoff Object Properties dialog, enter a descriptive name for the object, and click OK. On the Takeoff palette, double-click a takeoff object. The calculation is based on these dimensions.īefore starting, you should have clear ideas on center line method. On the Takeoff palette, select an object, and then click the Description value to enter editing mode. In this video, estimation is done for the ground level of the building.Īssume, there are three rooms with dimensions 4x5, 3x3, 3x5 (the first one is horizontal dimension and the second one is vertical dimension).

Autodesk quantity takeoff measure rectangle